90% of the fruit growers do not know, the autumn fertilization with Sany micro-digging, easy to be "hands-on shopkeeper"!

At the end of the summer, the autumn is thick and the temperature is getting cold. Many orchards have now completed the harvesting work. Experienced fruit farmers know that September is the best time for fruit trees to apply autumn fertilizer.

SY16C construction in yuzuyuan

The temperature was higher in September, the leaves did not completely fall off; the roots were still active, which was when the fruit trees were storing nutrients. At this time, fertilization, nutrition can be well accumulated, and will be used for growth when the spring is coming.

SY16C construction in the vineyard

Pay special attention to the depth of fertilization when fertilizing in autumn orchards. The root of the fruit tree has a characteristic that it will extend to the place where there is fertilizer. If the fertilization position is deeper, the fruit trees can be rooted deeper and the ability to resist drought and cold can be improved.

SY16C digging trenches in Liziyuan

In the past, Shi Qiufei used human labor; the pits dug were relatively shallow, about 10-15 cm; problems such as serious chemical fertilizer volatilization, tree roots floating, and root death often occurred.

SY16C weeding in orangery

Later, through the recommendation of friends, using Sany micro-digging and fertilizing; after a few digging, it reached 30-50cm, the fat pit was deep enough; the efficiency was also high, and the key cost was cheaper than labor, which is not a construction weapon.

Sany micro-excavation has the advantages of compact body, compact structure and flexibility; it can complete the conditions such as weeding and land reclamation, land leveling, trenching and fertilization, and transporting soil, which is a good helper to replace artificial. (This article is from Sany Heavy Industry)

Related News: Sany Micro Digging Flexible

Preform Mould

Features of the perform mold:
♦ No cutting of valve gate is employed to reduce the labor cost.
♦ Advanced hot runner system assures lower level of AA value.

♦ Reasonable-designed cold water channels increase cooling effect and shorten the cycle time.

The 1-16 cavity, the 24 cavity, the 32 cavity, the 48 cavity, the 72 cavity, the 96 cavity, and the 144 cavity bottle billet mold.

Bottle mouth
ROPP ALASKA, PCO1810, PCO1881, BPF
30/25, 29/2526/22,38mm, 48mm, 50-150mm
Equal specifications
Use machine
DEMARK, HUSKY, NETSTAL, KATA, etc.
Equipment.

Preform Mold, PET Preform Mold, Injection Preform Mold, Preform Mold for Injection Machine;

TAIZHOU WATON MACHINERY CO LTD , https://www.watonblowings.com