Metal rotor flow meter in the purchase, the installation process is mainly concerned about which aspects?

Each type of product has a need to pay attention to, what about Goldman Sachs Electric detailed introduction of the following:
1. The metal rotor flowmeter is suitable for measuring the flow rate of gas, liquid and steam with small diameter and low flow velocity. Due to the influence of certain viscosity, it is not suitable for measuring high-viscosity medium, nor is it suitable for measurement of pulsating medium flow.

2, used for process control instruments, the best accuracy of 1%, usually 1.5%, turndown ratio of 10:1.

3. When the flow rate exceeds 100m3/h, the flow rate and pressure loss are large.

4. In hazardous locations, it is necessary to use intrinsically safe explosion-proof, explosion-proof type flowmeters, etc. When measuring high-temperature and low-temperature media, it is best to use jacket type...

5, metal rotor flowmeter to avoid the magnetic field interference on the flowmeter, if there is more than one meter dense installation or carbon steel process pipeline, it is best to keep a certain distance with the instrument.

6. If the measurement contains a large amount of ferromagnetic granular media flow, you need to install a magnetic filter and purge regularly.

7. Before installing new piping, flush the piping.

8. It is better to use the vertical installation mode of lower and upper outlets. The import and export guarantees that there is a straight pipe section with 5 times of instrument diameter.

9. The upstream of the flowmeter should be equipped with valves, and the flow control valve should be installed at the downstream 5~10 times of the instrument diameter.

10. It is better to connect the bypass pipe when installing the instrument to facilitate future maintenance such as maintenance and replacement.

11. When the measured medium is dirty, the tube and float should be cleaned in time.

The above are its main considerations and I hope to help everyone.

1. Introduction of Waste Motor Oil Distillation Plant

Waste Motor Oil Distillation Plant ,is the new technology which can refine the waste motor oil into base oil(which can be made into diesel and gasoline after processed by our catalyst). The oil quality is better than the original normal pressure distillation technology, which show on purity ,transparence, lightness .this technology will do deodorization and destinke process to the raw material oil automatically by "dry type" vacuum pressure distillation method. With the vacuum distillation technology, the distillation temperature is considerably reduced, and the oil output will higher 5%-10% compared with original normal pressure distillation technology. It makes more profits to the enterprise virtually.

2. Raw material which can be used

    a. Waste oil .example: waste diesel, waste oil residue etc.

    b. tire/rubber oil

    c. plastic oil

    d. crude oil

e. waste engine oil

f. waste motor oil

g. waste lube oil

h. waste transformer oil

i. underground oil

3. Models of waste motor oil distillation plant

 4. Installation: We will be in charge of arranging our engineer to go to your place to guide the installation and train your workers how to operate the waste motor oil distillation plant ,and buyer will be in charge of the food, accommodation and round air tickets.

 5.Waste Motor Oil Distillation Plant Exporting Experience:

Waste Motor Oil Distillation Plant

Waste Motor Oil Distillation Plant,Used Motor Oil Regeneration Plant,Waste Oil Recycling Diesel Plant,Diesel Oil Distillation Plant

Shangqiu Sihai Energy Technology Co., Ltd , https://www.sihaienergy.com