Microcomputer Leather Nylon Zipper Belt Strap Cutting Machine Sogu Xb0151

September 22, 2018

  • Model NO.: Xb0151
  • Fuction: for Leather, Nylon, Wire, Pve, Paper, Zipper Strap
  • Cutting Width: 1-100mm
  • Trademark: SOGU
  • Specification: CE
  • HS Code: 33039609
  • Shoe Machinery: Microcomputer Leather Nylon Zipper Belt Strap Cutt
  • System: Microcomputer Control and Cut
  • Power: 1/4HP
  • Transport Package: Wooden Case
  • Origin: Zhejiang, Wenzhou
Name: Microcomputer Leather Nylon Zipper Belt Strap Cutting Machine Xb0151
 
Features 
 
1. Scope of application:  This strap cutting machine is suitable to cut heat shrinkage socket,cable wire,PVE socket,insulating paper,twin surface tape,bonding.tape,cotton belt& zipper etc. . 
 
2.  Microcomputer :  The machine adopts a microcomputer numerical control device to set the belt cutting length.
 
3. It is of high precision, low waste rate and simple to operate.
 
4. For sizing cutting use.
 
5. The machine can realize both straight cutting and inclined cutting.
 
6. High quality, efficiency and reliability
 
7. Long working life 

Matters needing attention
 
1) moving workbench or spindle, according to the distance and artifacts, correctly selected movement speed, beware of collision when moving too fast.
2) when programming according to the actual situation to determine the correct processing technology and processing route, prevent due to insufficient processing position or on intensity artifacts caused by insufficient scrap or cut off the drop in advance.
Must be confirmed before 3) wire cutting program and the amount of compensation is correct.
4) check whether the wire electrode tension is enough. When cutting taper tension should be down to the usual half.
5) check the wire electrode of proper feeding speed.
6) according to the actual situation of work piece choose open or close the machining, on the premise of avoiding interference as far as possible to shorten the distance between nozzle and workpiece. The process, the distance between nozzle and workpiece generally take 0.05 ~ 0.1 mm.
7) check the jet choose whether reasonable, with high-pressure jet when rough machining, finish machining with low pressure jet.
8) slice observation should be paid attention to when processing stability, found that bad when adjust.
9) during processing, often should inspect the cutting condition monitoring, found the problem immediately.
 
 
Technical Parameter
 

cutting width
1-100mm

cutting length:
1-99999mm

power voltage
220V/1 PHASE/50Hz

weight
34kg

dimension
500x450x450mm

Iron Casting

Sand Casting,Engineering Machinery Parts,Iron Casting

Stamping Part Co., Ltd. , http://www.nscnc-machining.com